有時候雙組份打膠機打出的膠體可能出現混合不均勻的現象，影響著產品的質量！下面雙組份打膠機廠家的小編就給大家介紹一下造成結構膠混合不均勻的原因！
Sometimes the colloid produced by the two-component glue beater may appear uneven mixing phenomenon, affecting the quality of the product! The following two-component glue maker's small edition will introduce to you the causes of uneven mixing of structural glue!
混合不均勻的結構膠有以下四種情況及原因如下：
There are four kinds of uneven mixing structural adhesives and the reasons are as follows:
①連續花膠：一般是混合器堵塞、混合器裝配錯誤或者使用的混合單元不夠多;
(1) Continuous gum: generally, the mixer is blocked, the mixer assembly is wrong or the mixing unit is not enough;
②斷續有規律花膠：與系統性故障有關，如配比泵密封泄漏或者比例架磨損;
(2) Intermittent regular pattern gum: related to systemic faults, such as leakage of seal of proportioning pump or wear of proportioning frame;

③斷續無規律花膠：與故障有關，如過濾器堵塞/針閥堵塞/壓盤故障/配比泵入口堵塞或者密封失效/安全閥及高壓球閥失效等;
(3) Discontinuous irregular pattern gum: related to faults, such as filter blockage/needle valve blockage/platen failure/ratio pump entrance blockage or seal failure/safety valve and high pressure ball valve failure;
④短暫停槍后又開槍時，開頭出現一段花膠：主要是膠粘度匹配不理想，需要調整系統管道或降低工作壓力。
(4) When the gun stops for a short time and fires again, a section of gum appears at the beginning: the main reason is that the gum viscosity matching is not ideal, and the system pipeline needs to be adjusted or the working pressure should be reduced.
今天的精彩內容就暫且給大家介紹到這里了，歡迎大家百度搜索：雙組份打膠機，這樣可以找到我們，我們會定期發布更多的相關資訊，大家也可以直接收藏我們的官網：http://www.jianyoucc.cn！謝謝大家長久以來的支持！
Today's wonderful content will be introduced here for the time being. Welcome to Baidu Search: Two-component glue machine, so that we can find us, we will regularly release more relevant information, you can also directly collect our official website: http://www.jianyoucc.cn! Thank you for your long-standing support!